2018 Dragon Products, LTD Stimulation Equipment Cementer

Complete frac spread equipment and support in every shale play. From the toughest frac pumps and blending units to water transfer to the most advanced data control systems Dragon manufactures everything in house to ensure the highest quality. Plus we have parts and service centers located in every major North American hydrocarbon area, staffed with frac experts who know how to deploy our equipment to best fit your project. Whether you need the complete frac spread or the smallest water transfer pump Dragon has a solution.

• Twin CAT C-15 Diesel Engines, 595 Hp with CX31-P600 Transmission

• CAT C-7 Diesel Engine, 275 HP with integral 4-Pad Funk PTO Drive

• (2) AXON HD500 Triplex Pumps

• High Energy Re-Circulating Jet Mixer and Diffuser

• 10 BBL Mixing Tank (2) sections with (2) Agitators

• 20 BBL Displacement Tank (2) 10 BBL sections (with markers)

• (2) Dragon 6 x 5 x 11 Centrifugal Pumps (Boost and Recirculation)

• (2) Dragon/Mission 3 x 4 Centrifugal Pumps (Mix Water and redundant)

• 3 Densitometer in the Re-Circ mixing line

• CAT C-7 Diesel Engine, 275 Hp with integral 4-Pad Funk PTO Drive

• Air compressor, air tank and air system complete with air filter, air dryer, air-water separator and all necessary valves and hoses.

• (4) Sauer-Danfoss Series 90 Pumps (closed loop hydrostatic for C-Pumps)

• (4) Sauer-Danfoss Series 90 Hydraulic Motors (closed loop hydrostatic for C-Pumps)

• Sauer-Danfoss Series 45 Load Sense work function pump

• Sauer-Danfoss PLUS+1 Electronic Controls (with Manual Back-up)

• Fine Tuning Flows with 3-turn Rheostats

• Hydraulic oil reservoir and hydraulic cooler

Height 13 (4 m), Length 44 (13.4) Width 8-6 (2.6 m)

Single Drop Deck Tri-Axle Unit with Fifth Wheel towing arrangement.

Two CAT C15 diesel engines on the unit, each rated for 600 HP at 2100 rpm

Installed on the rear of each engine is a Caterpillar CX31-P600 transmission.

Each Transmission is connected to the pump via a heavy duty drive line installed at an angle no greater than as specified by the manufacturer with a metal guard with suitable access points for greasing and maintenance of the yokes.

Installed above the transmissions is a dual compartment tank with a capacity of 22 Barrels. The tanks are oriented so that the operator can view the entire tank volume from the operators platform.

• High energy re-circulating mixer

• Bulk air separator (diffuser)

• Bulk cementing metering valve

• 10 BBL Steel Mixing tank with agitator and hydraulic motor, speed controlled

• (2) sections, Boost and Recirculate

Full control and storage deck with covered aluminum control panel.

• Density Control System, Tub level Control System, Absolute Density Measurement System, Data Acquisition Systems

• 130 F Cooling Package